Circa holder?

I'm about finished with my Harvard remake. So, I'm slowly building my circa requirements for the finished project, all classic sized.

Right now, in the back of the Harvard is a plastic sleeve with a slit in the left hand side. This allows for a small address book to be slid in and easily accessible from the back. I've looked at the circa Sheet Protectors, but I'm guessing that they are top fill. So, I'm figuring I'll have to to a RYO. Suggestions?

On just looking at the one in this Harvard, I might be able to cut it out and punch it! There's a good bit of room between the spiral bound holes and where the slit is.

Jason

Syndicate content